Your furnace is a key part of your home. Without one, you wouldn’t be able to stay warm during the winter. Yet furnaces can have some issues that are more typical than others.

Let’s review these issues and discuss what they might cost to correct so you know before you call an HVAC technician. Some of the most common furnace repair issues include:

  • Furnace won’t turn on
  • Furnace doesn’t stay lit
  • Furnace won’t blow hot air
  • Furnace won’t turn off

1. My Furnace Won’t Turn On

There are a few reasons why your furnace won’t turn on, so make sure to go through all of them.

  • Is your thermostat set correctly? Make sure it’s set to “heat,” “auto” and that your preferred temperature is greater than the room’s current temperature. If you have a programmable thermostat, make sure it has fresh batteries.
  • Is the circuit breaker tripped? Your furnace can’t operate if it doesn’t have electricity. Reset the switch if it’s facing the outside of the electrical panel.
  • Is the furnace switch off? Your furnace has a power switch found on or near it. Since this switch resembles a light switch, it’s easy to unintentionally turn it off. If it was off, it may take your furnace a few minutes to turn on.
  • Is the air filter clean? A dirty air filter can create a lot of problems for your furnace. Get a new one if you can’t see light through it.

Estimated Repair Cost

This issue can be complex, so the estimated cost to repair it depends on what’s wrong.

2. The Furnace Isn’t Staying Lit

Your furnace follows a certain sequence when it starts heating your home.

  1. Your thermostat notices the temperature has fallen and tells your furnace to start running.
  2. The draft inducer fan turns on to bring in fresh air for combustion.
  3. The gas valve unlocks for the burners, which are ignited electronically.
  4. The flame sensor signals to your furnace the burners have been lit.

If something is wrong during the sequence, your furnace will shut off as a safety precaution.

A couple of potential causes for this problem include:

  • Dirty or malfunctioning flame sensor. If the sensor doesn’t sense a flame, it will turn off your furnace to keep natural gas from getting into your home. The ignition process corrodes flame sensors as time passes. While cleaning during annual furnace maintenance can help, yours may ultimately need to be replaced.
  • Bad limit switch. This safety feature will turn off your furnace if it senses backdrafting. Backdrafting is dangerous, because carbon monoxide and natural gas can seep into your home. These switches can fail due to age, damage or dust buildup.
  • Old thermostat. If your thermostat isn’t working correctly, your furnace won’t be able to operate.
  • Dirty air filter. A dirty air filter can reduce airflow and force your furnace to shut down to prevent overheating. Make sure to replace yours every 30 to 90 days, or whenever you can’t see light through it.

Estimated Repair Cost

These costs are estimates, so it’s important to note yours may fluctuate based on your furnace’s brand and model.

  • Flame sensor: $350–$500
  • Limit switch: $150–$300
  • Thermostat: $150–$350
  • Furnace filter: $10-$30

3. The Furnace Won’t Blow Hot Air

In many instances, this problem is linked to an incorrect thermostat setting or a dirty air filter that’s restricting airflow. Use the steps above to resolve the problem.

4. My Furnace Can’t Stop Running

If it’s very cold outside or you like your home to be warm, your furnace may be running for a long time.

If this isn’t the case, make sure your thermostat is set correctly and running properly. If your fan setting is at “on,” the blower motor will be going even when the furnace isn’t, so it’ll sound like your furnace is running all the time.

Alternatively, there might be a problem with the blower motor or your ductwork may be losing air, making your furnace run constantly to make up for the air loss.

Estimated Repair Cost

These costs are estimates, so it’s necessary to note yours may vary based on your furnace’s brand and model.

  • New blower motor: $250–$800
  • Seal ductwork: varies based on square footage

Ambience HVAC, Inc. Can Resolve Your Furnace Issues as Soon as Possible

Furnace issues can be an expensive headache, but not when you call Ambience HVAC, Inc.. We’ve been providing the quality, affordable furnace repair Wilmington homeowners have trusted since year. Call us at 302-239-HVAC (4822) to request your free estimate today.